Description
DescriptionThe Rock Hard Jeep JK Wrangler Rear Bumper/Tire-Carrier is the only JK rear bumper on the market today that is made out of 1/4″ thick plate steel. Designed with tapered ends for increased departure angles, this bumper will hold up to a 38″ tire, comes standard with an integrated Class 2 hitch receiver, CB antenna mount, a horizontal Hi-Lift Jack mount with padlock provision and two 5/8″ x 2-1/2″ CNC D-Ring shackle mount with tabs that are welded on front, go through bumper and then are welded on the backside as well. All necessary hardware necessary for the installation is provided and an optional Jerry Can Mounts and a Rock Rack are all available for purchase separately.
Shown with Tire Carrier.
The Rock Hard Jeep JK Wrangler bumper tire carrier swings on 1 1/4″ shaft, 2 3/4″ hub with upper and lower sealed tapered roller bearings. Zerk fittings allow you to fill the hinge with grease. Also, notice the A-Frame swing stop built into the bumper. Spring loaded auto-locking pin system. Tire carrier locks in the open position so it will not swing back at you. To close, just lift tee handle on the pin and let it swing shut. An Integrated class 2 trailer hitch comes complete with safety change mounts.
Check out the matching Front Bumper to complete the look of your Jeep!
Installation NotesInstallation Difficulty:Level 3Advanced
1. Bumper without Tire Carrier is not Designed to accept the Tire Carrier at a later date.
Installation Time:2-4 hoursParts Included
Rear Bumper with Tire Carrier
Installation Hardware
Reviews
There are no reviews yet.